1 Topic by adrian.heigold

  • adrian.heigold
  • New member
  • Offline
  • Registered: 2023-11-12
  • Posts: 1

Topic: Divmmc not working and cant flash

I have purchased a Divmmc Future. And when i insert it into a spectrum+3 with no card inserted. The machine boots to the selection screen. When i insert the sd card (that i purchased along with the Divmmc Future) I get a screen with blocks and lines on it.
I have loaded the flash firmware 0.8.9 via the tape lead. but when i press enter it says CANNOT FLASH   DIVIDE ERROR.

I know i am supposed to remove the sd card to ADJUST FLASH FUSE JP2/E. But i cant do this. As i insert the sd card the machine crashed to the blocky screen.

Is there any other way to flash repair this card ???

Any suggestions very grateful.

2 Reply by Spezzi63

  • Spezzi63
  • esxDOS Fan
  • Offline
  • Registered: 2016-03-18
  • Posts: 69

Re: Divmmc not working and cant flash

https://www.youtube.com/watch?v=cYa3HaCs3wQ

You can go through this video again and maybe determine what is causing it.
Remember, DivMMC system must be the same on "Flash" and on the SD card.